2003 Mazda Bongo

Front Vehicle structure is corroded but structural rigidity is not significantly reduced just outside prescribed area (6.1.1 (c) (i))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced inner sill coroded and holed not whithin prescribed area (6.1.1 (c) (i))

all front and rear underbody and suspension corroded

all front to rear underbody undersealed

front radiatior crossmember corroed

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside rear hub oil seal, signs of leakage, recommend attention.

Offside front outer driveshaft gaiter cracking, keep check on.

Parking brake efficiency slight low, recommend inspection, possible adjustment required.

Tyres becoming low, 2-3mm, limit 1.6mm.

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Registration plate lamp not working (1.1.5c)

Offside front outer driveshaft gaiter cracking, keep check on.

Parking brake efficiency slight low, recommend inspection, possible adjustment required.

Tyres becoming low, 2-3mm, limit 1.6mm.

Nearside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Registration plate lamp not working (1.1.5c)

Offside Rear Stop lamp not working (1.2.1b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)