1998 Hyundai Lantra

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust engine idle speed too high (7.3.D.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Registration plate lamp not working (1.1.5c)

Offside Outer Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

all five seat belts difficult to release under pressure

both inner & outer sills corroded

engine oil level low, topped up

power steering pipe corroded

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Oil leak

Brakes imbalanced across an axle (3.7.B.5b)

Headlamp aim too low (1.8)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.5c)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Shock absorber has an excessively worn shock absorber pivot (2.7.4)

Nearside Rear Tie bar/rod has excessive play in a ball joint (2.4.G.2)

Nearside Registration plate lamp not working (1.1.5c)

Offside Rear Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Tie bar/rod has excessive play in a ball joint (2.4.G.2)

Offside Registration plate lamp not working (1.1.5c)

battery flat

oil leak from hole in sump

unable to identify vehicle correctly on computer....standard emissions check carried out

Centre Exhaust has part of the system slightly deteriorated (7.1.1a)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front registration plate deteriorated (6.3.1d)

Rear registration plate deteriorated (6.3.1d)

Centre Exhaust has part of the system slightly deteriorated (7.1.1a)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Front registration plate deteriorated (6.3.1d)

Offside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Macpherson strut has slight play in the sliding bush or gland (2.5.B.1b)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)