1998 Subaru Impreza

Emissions not tested (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (8.1.1 (a))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front coil spring corroded (2.4.C.1b)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Rear coil spring corroded (2.4.C.1b)

Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

rear bumper is insecure

Exhaust has a minor leak of exhaust gases (7.1.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Registration plate lamp not illuminating the registration plate (1.1.C.1e)

rear bumper is insecure

Rear Shock absorber has a slightly reduced damping effect (2.7.5)

the no plate lamp is secure but could be better nearside lamp is dim

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Registration plate lamp insecure (1.1.C.1c)

Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Rear wheel bearing has excessive play (2.6.2)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust system not adequately supported (7.1.1)

Offside Registration plate lamp not working (1.1.5c)