2003 Toyota Land Cruiser

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Exhaust emits clearly visible black smoke during acceleration (8.2.1.2 (g))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Headlamp has a product on the lens so that the light output is severely reduced Both Front (4.1.4 (b))

Nearside Front Upper Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting (6.2.2 (d) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Upper Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting (6.2.2 (d) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Nearside Rear Sub-frame attachment bracket/mounting likely to become detached (5.3.3 (a) (ii)) DANGEROUS

Offside Rear Sub-frame attachment bracket/mounting likely to become detached (5.3.3 (a) (ii)) DANGEROUS

Axle deformed but serviceable (5.1.1 (a))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security ALL (6.2.2 (d) (i))

Front & Rear Suspensions Are Corroded & Exhaust System Is Corroded

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Fuel Pipe/s corroded ()

Nearside Front Suspension component ball joint has slight play (5.3.4 (a) (i))

Power steering pipe/hose slightly corroded (2.1.5 (g) (i))

Service brake binding but not excessively Both Rear (1.2.1 (f))

Suspension component pin or bush slightly worn Both Front (5.3.4 (a) (i))

Vehicle Has Covers Fitted Unable To See Certain Testable Items

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security ALL (6.2.2 (d) (i))

fuel tank straps corroded, tank fully secure as held in with a cradle

rear axle corroded

rear shocker bushes slightly deteriorated

front radiator support bar badly corroded, non structural, ok at time of test

general underside corrosion

headlamp lens covers deteriorated

rear chassis and body mountings badly corroded but not in prescribed area and body still fully secure on the chassis with the other mounts

the tow bar has been removed by the owner which it had failed on

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Vehicle structure is so weakened by damage within 30cm of a towbar mounting, the towbar is likely to become detached rear cross member (6.1.6 (i) (ii)) DANGEROUS

front radiator support bar badly corroded, non structural, ok at time of test

general underside corrosion

headlamp lens covers deteriorated

rear chassis and body mountings badly corroded but not in prescribed area and body still fully secure on the chassis with the other mounts

front brake back plates corroded

front engine under shield corroded

front inner wings corroded

front towing eye corroded but not related to steering, braking or suspension

general under side and chassis light corrosion

headlamp lens covers deteriorated

n/s front tyre worn on the outer edge

n/s rear body mounting badly corroded but body still securely mounted

slight bind on the o/s rear brake

Front Both brake backplates corroded

Front Headlamp has a product on the lens but not seriously reducing light output Both headlamps (4.1.4 (b))

Rear Body mounting fixing insecure, but overall security not significantly reduced Both rear body mountings corroded but front six mountings are in good condition and overall body integrity secure (6.2.2 (c) (i))

Rear Washer inoperative

Rear Anti-roll bar damaged and seriously weakened Stabilizer bar on rear axle snapped (5.3.3 (b) (i))

Front Both brake backplates corroded

Front Headlamp has a product on the lens but not seriously reducing light output Both headlamps (4.1.4 (b))

Rear Body mounting fixing insecure, but overall security not significantly reduced Both rear body mountings corroded but front six mountings are in good condition and overall body integrity secure (6.2.2 (c) (i))

Rear Washer inoperative

headlamp lens covers slightly deteriorated

both rear body mountings are slightly corroded

o/s rear brake disk is slightly corroded

n/s headlamp aim just in tollerances

o/s rear brake disc corroded

rear body mountings corroded

Exhaust has a major leak of exhaust gases repaired with sealant (6.1.2 (a))

n/s headlamp aim just in tollerances

o/s rear brake disc corroded

rear body mountings corroded

Nearside rear brake binding (3.7.B.1)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Lower Ball joint has slight play (2.2.B.1f)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Front registration plate character(s) incorrectly spaced (6.3.4a)

Nail in offside front tyre

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Stop lamp not working (1.2.1b)

underbody rusty

Nail in offside front tyre

underbody rusty

Brake pedal anti-slip provision missing (3.3.A.1b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside front brake binding (3.7.B.1)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Headlamp not in good working order adversely affecting beam image (1.2.4a)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Tyre worn close to the legal limit (4.1.E.1)