1998 BMW Z3

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear heatshield insecure

both rear tyres worn inside edges

power steering area damp

Front Suspension component corroded and seriously weakened cross bar off subframe (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Lower Anti-roll bar linkage pin or bush excessively worn bush (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear heatshield insecure

both rear tyres worn inside edges

power steering area damp

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Central Exhaust has a major leak of exhaust gases (7.1.2)

Central Rear Stop lamp has less than 50% of the light sources illuminating (1.2.1b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Rear Inner Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Inner Brake pipe excessively corroded (3.6.B.2c)

Exhaust has a minor leak of exhaust gases centre pipe (7.1.2)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded front to rear (3.6.B.2c)

Offside Rear Brake pipe slightly corroded front to rear (3.6.B.2c)

Centre Brake pipe slightly corroded both front to rear (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front coil spring broken (2.4.C.1a)

Offside Rear fog lamp not working (1.3.2b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Headlamp aim too low (1.8)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Steering system slightly tight (2.2.D.1)

Nearside Front Shock absorber has negligible damping effect (2.7.5)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Shock absorber has negligible damping effect (2.7.5)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim too low (1.8)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Steering system slightly tight (2.2.D.1)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

both rear brake pipes corroding

both rear coil springs corroding

n/s handbrake reading very poor

n/s/f tyre bald on inner edge + close to limit

o/s/f tyre going bald on inner edge

surface corrosion steering column

both front anti roll bar drop link bushes heavily split on limit

both rear coil springs corrroding

slight ridge front brake discs + pads very thin on limit

exhaust mount corroding

front brake pads look thin