1998 Mercedes-benz Vito

Nearside Front Windscreen washer not working (3.5 (a))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced lower mount point (inner sill under body) (7.1.1 (a) (i))

Offside Front Windscreen washer not working (3.5 (a))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Anti-roll bar linkage damaged but not seriously weakened (5.3.3 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive inner sill under body (near subframe mounting point) (5.3.6 (a) (i))

Offside Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Obligatory mirror missing (3.3 (a))

Offside Registration plate lamp likely to become detached (4.7.1 (c) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen washer not working (3.5 (a))

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure side wall (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre has a tear, caused by separation or partial failure of its structure side wall (5.2.3 (d) (ii)) DANGEROUS

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Front Exhaust has a major leak of exhaust gases cat section. (6.1.2 (a))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Brake pipe corroded, covered in grease or other material slightly corroded (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

o/s + n/s front inner wing panels corroded, under bonnet

Exhaust has a minor leak of exhaust gases front (7.1.2)

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Exhaust has a minor leak of exhaust gases front (7.1.2)

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Brake cable has wires broken and is significantly weakened (3.5.1b)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Inner Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Inner Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

n/s front inner sill corrode +holed , not secified area

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

windscreen marked .o/s wiper edge

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Registration plate lamp not working (1.1.C.1d)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

windscreen marked .o/s wiper edge

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Oil leak

inner sills slightly corroded

o/s front brake binding slightly

Oil leak

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

front brake inbalance 23%

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Registration plate lamp not working (1.1.C.1d)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

front brake inbalance 23%

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly damaged (2.2.D.2b)

Rear Brake pipe slightly damaged (2.2.D.2b)

Outer Front Seat belt locking mechanism does not secure or release (5.2.5a)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly damaged (2.2.D.2b)

Rear Brake pipe slightly damaged (2.2.D.2b)

Centre Seat belt attachment fitting slightly deteriorated (5.2.3)

Nearside Headlamp not working on dipped beam (1.7.5a)

Centre Seat belt attachment fitting slightly deteriorated (5.2.3)

Fuel pipe leaking (7.2.3)

Nearside Front Windscreen wiper blade deteriorated (8.2.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Windscreen wiper blade deteriorated (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Fuel system component leaking (7.2.3)

Offside Rear fog lamp not working (1.3.2b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Shock absorber has slight corrosion to the casing (2.7.2a)