2008 Saab 9-3

Nearside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Exhaust has a minor leak of exhaust gases flexy (6.1.2 (a))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

handbrake travel high

Lower Steering column universal joint has excessive wear or play (2.2.2 (c))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt split (6.1.7 (g) (ii))

Nearside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

handbrake travel high

Nearside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords Inside tread (5.2.3 (d) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre worn close to the legal limit only on outer edge (4.1.E.1)

Offside Front coil spring broken (2.4.C.1a)

Nearside Front Tyre worn close to the legal limit only on outer edge (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Power steering component(s) has slight seepage from a seal (2.3.3b)

Rear Brake pad(s) wearing thin (3.5.1g)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components