1998 Mercedes-benz Vito

Brake load sensing valve stiff (1.1.17 (c) (ii))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Play in steering rack inner joint(s) ()

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Brake load sensing valve inoperative (3.6.E.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Headlamp aim too high (1.8)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Outer Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear coil spring broken (2.4.C.1a)

Offside Rear coil spring broken (2.4.C.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)