1998 Rover Mini

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Play in steering rack inner joint(s) ()

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength END OF OUTER SILL (5.3.6 (a) (i))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength FLOOR (5.3.6 (a) (i))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength FLOOR (5.3.6 (a) (i))

Nearside Front Inner Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive FLOOR (5.3.6 (a) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive FLOOR (5.3.6 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Front Upper Suspension arm ball joint dust cover severely deteriorated inner (5.3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

both front outer cv boots cracking

fuel pipes corroding, brake pipes covered in grease

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Inner Subframe mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

both front outer cv boots cracking

fuel pipes corroding, brake pipes covered in grease

Nearside Front Upper Suspension component ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Floor pan as marked (6.2.2 (d) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Front Exhaust has a major leak of exhaust gases exhaust flexi (6.1.2 (a))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Front brake pads 80% worn

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Subframe mounting prescribed area is excessively corroded floor (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is excessively corroded rear subframe front mount = wheel arch (2.4.A.3)

Offside Front Upper Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Subframe mounting prescribed area is excessively corroded boot floor (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded front of rear subframe mount = wheel arch (2.4.A.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Front Front wheel bearing rough when rotated (2.5.A.2)

Offside Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Offside Rear Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Registration plate lamp not working (1.1.C.1d)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Headlamp aim too low (1.8)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Body has slight corrosion (6.1.B.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Body has slight corrosion (6.1.B.2)

Centre Brake pipe excessively corroded (3.6.B.2c)

Nearside Front wheel bearing has excessive play (2.5.A.3c)

Nearside Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Sub-frame corroded and seriously weakened (2.4.G.1)

Rear registration plate deteriorated (6.3.1d)

Nearside Body has slight corrosion (6.1.B.2)

all suspension units deteriating

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Body has slight corrosion (6.1.B.2)

all suspension units deteriating

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)