1998 Nissan Primera

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Emissions not tested rear exhaust broken off (8.2.1.2 (d))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Oil leaking excessively from engine (8.4.1 (a) (i))

Rear Brakes imbalanced across an axle 41% (1.2.1 (b) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Exhaust system insecure (6.1.2 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Tyre has ply or cords damaged (5.2.3 (d) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. 29% (1.2.1 (b) (i))

Front wiper spindles very badly worn

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive quarter panels corroded (5.3.6 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Central Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Sills all been welded and repair on both sides

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (Outer Sill) (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (Sill) (5.3.6 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (Outer sill) (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced (Outer Sill) (7.1.1 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Battery insecure (1.9.1)

Nearside Front Brake hose excessively deteriorated (3.6.B.4d)

Nearside Rear Inner Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Front Brake hose excessively deteriorated (3.6.B.4d)

Offside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Outer Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Upper Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Rear Outer Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Upper Suspension arm has slight play in a pin/bearing (2.4.G.2)

Nearside Front Upper Suspension arm has excessive play in a pin/bearing (2.4.G.2)

Nearside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Upper Suspension arm has slight play in a pin/bearing (2.4.G.2)

Nearside Inner Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Inner Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear registration plate deteriorated (6.3.1d)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Nearside Inner Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Inner Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Inner Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Outer Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Brake pipe excessively corroded (3.6.B.2c)

Offside Stop lamp not working (1.2.1b)

Nearside Inner Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Outer Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)