1998 Mazda MX-5

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust has a major leak of exhaust gases rear joint (6.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Headlamp levelling device inoperative (4.1.5 (a))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis by anti roll bar mounting (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis in arch (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Position lamp light intensity significantly reduced (4.2.3 (a) (ii))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear fog lamp switch inoperative (4.5.3 (a))

Rear fog lamp tell-tale not working (4.9.1 (a) (ii))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Hazard warning tell-tale inoperative (4.9.1 (a) (i))

Nearside Indicator tell-tale inoperative (4.9.1 (a) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

numerous areas of corrosion including components

All 4 tyres are slightly perished

Front Suspension component mounting prescribed area is corroded but not considered excessive N/S&O/S (5.3.6 (a) (i))

Headlamp has a product on the lens but not seriously reducing light output N/S&O/S (4.1.4 (b))

Seat belt anchorage prescribed area is corroded but not considered excessive N/S&O/S (7.1.1 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

All 4 tyres are slightly perished

Front Suspension component mounting prescribed area is corroded but not considered excessive N/S&O/S (5.3.6 (a) (i))

Headlamp has a product on the lens but not seriously reducing light output N/S&O/S (4.1.4 (b))

Seat belt anchorage prescribed area is corroded but not considered excessive N/S&O/S (7.1.1 (a) (i))

Brake performance unable to be tested (1.2.1 (g))

Emissions unable to be completed (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Side repeater missing (4.4.1 (a) (ii))

Nearside Rear Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

All 4 tyres are slightly perished

Front Suspension component mounting prescribed area is corroded but not considered excessive N/S&O/S (5.3.6 (a) (i))

Headlamp has a product on the lens but not seriously reducing light output N/S&O/S (4.1.4 (b))

Seat belt anchorage prescribed area is corroded but not considered excessive N/S&O/S (7.1.1 (a) (i))

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Rear coil spring broken N/S & O/S (2.4.C.1a)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Suspension component mounting prescribed area is corroded but not considered excessive N/S & O/S (2.4.A.3)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Headlamp not working on dipped beam (1.7.5a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

front brake pads low

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

offside rear tyre cracking / perished

Emissions not tested (7.0)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

offside rear tyre cracking / perished

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

engine overheated on mot test

nearside front tyre cracking / perished tread area

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

nearside front tyre cracking / perished tread area