2000 Lexus IS200

Electronic stability system warning lamp indicates a fault (3.4.1c)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too low (1.8)

Nearside Rear Body has a sharp edge caused by damage (6.1.C.1)

Nearside Rear Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear position lamp(s) insecure (1.1.A.3a)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear position lamp(s) insecure (1.1.A.3a)

Battery insecure (1.9.1) DANGEROUS

Offside rear parking brake recording little or no effort (3.7.B.6a) DANGEROUS

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Exhaust has a minor leak of exhaust gases (7.1.2)

Oil leak

Nearside Front Wheel nut(s) missing (4.2.A.1e)

Nearside Headlamp aim too low (1.8)

Nearside Rear Wheel nut(s) missing (4.2.A.1e)

Nearside front brake binding (3.7.B.1)

Offside Rear Wheel nut(s) missing (4.2.A.1e)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front Service brake application uneven across the axle (3.7.D.2b)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Wheel nut(s) missing (4.2.A.1e)

Offside Front Service brake indicates brake bind (3.7.D.2a)

Offside Front Wheel nut(s) missing (4.2.A.1e)

Offside Rear All position lamps not working (1.1.A.3b)

Offside Rear Stop lamp not working (1.2.1b)

Rear An item not tested (Manual)

Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)

Nearside Rear Ball joint has excessive play (2.2.B.1f)

Nearside Rear Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Parking brake lever has no reserve travel (3.1.6b)

Rear Rear passenger seat cannot be secured in the upright position. (6.2.3)

Registration plate lamp not working (1.1.5c)

Statutory seat belt missing (5.1.1)

Suspension arm locating pin locking device missing (2.4.G.3b)

Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim too low (1.8)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Inner Front brake disc excessively pitted (3.5.1h)

Offside Rear Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Parking brake lever has no reserve travel (3.1.6b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Rear Vehicle structure has an inadequate repair, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Suspension joint offside lower dust cover split/missing

front no plate starting to deteriorate

Offside Headlamp aim too high (1.8)

front no plate starting to deteriorate

Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Registration plate lamp not working (1.1.5c)

Offside Rear Shock absorber has a light misting of oil (2.7.3)