1998 Subaru Impreza

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

unable to properly inspect welding due to excessive underseal

Nearside Front Suspension arm corroded and seriously weakened (2.4.G.1)

Offside Front Suspension arm corroded and seriously weakened (2.4.G.1)

Offside Front Suspension component mounting prescribed area is excessively corroded jacking point (2.4.A.3)

Brake pipe slightly corroded (3.6.B.2c)

all tyres worn on edges

Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

rear discs pitted

Oil leak

Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

front and rear diff seals leaking

front antiroll bar pin bushes cracked

Nearside Headlamp aim too low (1.8)

Nearside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Offside Headlamp aim too low (1.8)

Offside Registration plate lamp not working (1.1.C.1d)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1a)

front and rear diff seals leaking

front antiroll bar pin bushes cracked

Nearside Front Macpherson strut is slightly stiff in the upper support bearing assembly (2.5.B.1b)

Front Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

N/S/F Tyre worn slightly on outer edge

Nail in nearside rear tyre

Nearside Front Headlamp aim too low (1.8)

O/S/F Tyre has slight damage to outer sidewall , no cords showing

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Stop lamp not working (1.2.1b)

n/s front tyre has a superficial damage to sidewall

Brake pad(s) wearing thin (3.5.1g)

Brake pad(s) wearing thin (3.5.1g)

Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (4.1.E.2a)

Nearside Rear Brake pipe inadequately clipped (3.6.B.1)