1998 Mazda MX-5

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Horn not working (7.7 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Rear Suspension component mounting prescribed area is inadequately repaired sill repaired with expanding foam (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength entire sill corroded (5.3.6 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Position lamp light intensity significantly reduced (4.2.3 (a) (ii))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength entire sill corroded (5.3.6 (a) (i))

Oil leaking excessively from engine (8.4.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Electrical wiring likely to drag on the ground (4.11 (a) (iii)) DANGEROUS

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Brake pedal wearing smooth (1.1.2 (c))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust noisy (8.1.1 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension arm corroded but not seriously weakened all front arms corroded (5.3.3 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Exhaust mounting defective (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension arm corroded but not seriously weakened all rear arm s corroded (5.3.3 (b) (i))

Brake pedal wearing smooth (1.1.2 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension arm corroded but not seriously weakened both front upper and lower arms (5.3.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill/arch (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill / arch (5.3.6 (a) (i))

Offside Rear Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Suspension arm corroded but not seriously weakened both rear arms (5.3.3 (b) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Brake pedal wearing smooth (1.1.2 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill/arch (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill/arch (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

general corrosion to suspension components

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced sills corroded (6.1.1 (c) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

general corrosion to suspension components

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Driver's airbag missing (7.1.5 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Registration plate insecure (0.1 (a))

Hazard warning switch inoperative missing (4.4.2 (a) (ii))

Horn not working (7.7 (a))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Exhaust noisy (8.1.1 (a))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced sills corroded (6.1.1 (c) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

general corrosion to suspension components

general corrosion to underside of vehicle

Different size wheels and tyres fitted front to rear.

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

General corrosion on front and rear suspension.

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

ns and os lower sills corroding.

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

corrosion in both outer sills and both front chassis rails

different size wheels and tyres fitted front to rear

Exhaust has a major leak of exhaust gases front/centre join (7.1.2)

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)

Offside Front position lamp(s) not working (1.1.A.3b)

Parking brake: efficiency below requirements (3.7.D.4)

Rear Exhaust has a major leak of exhaust gases box missing (7.1.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

corrosion in both outer sills and both front chassis rails

different size wheels and tyres fitted front to rear

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Parking brake recording little or no effort (3.7.D.3a)

Offside Parking brake recording little or no effort (3.7.D.3a)

Parking brake: efficiency below requirements (3.7.D.4)

Windscreen washer provides insufficient washer liquid n/s and o/s (8.2.3)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

corrosion o/s/f chassis rail

different size tyres fitted front to rear

front chassis legs corroding

general underbody corrosion

Nearside Front Outer Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

front chassis legs corroding

general underbody corrosion

n/s/f brake slightly binding

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Upper Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Under-trays fitted obscuring some underside components

Vehicle's internal headlight adjuster altered to recheck lights

genral surface corrosion underbody

Nearside Front Power steering pipe(s) or hose(s) leaking (2.3.3b)

Coolant leak

Oil leak

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Under-trays fitted obscuring some underside components

Vehicle's internal headlight adjuster altered to recheck lights

genral surface corrosion underbody

light corrosion front chassis legs

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

light corrosion front chassis legs

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Outer Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Registration plate lamp not working (1.1.5c)

Front registration plate character(s) not correctly formed (6.3.4b)

Nearside Registration plate lamp not working (1.1.5c)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too far to the left (1.8)

Parking brake lever has no reserve travel (3.1.6b)

Rear registration plate character(s) not correctly formed (6.3.4b)

Nearside Inner Front Brake pad(s) less than 1.5 mm thick (3.5.1g) DANGEROUS

Offside Inner Front Brake pad(s) less than 1.5 mm thick (3.5.1g) DANGEROUS

Nearside Headlamp aim too high (1.8)

Offside Rear fog lamp not working (1.3.2b)

Offside Registration plate lamp not working (1.1.C.1d)

wipers smearing windsreen