1998 Mazda MPV

Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting cross member completely rotted out and has been fibre glassed (6.2.2 (d) (i))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing as marked inside engine bay (5.3.6 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting side door step as marked (6.2.2 (d) (i))

Nearside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced inner and outer body sills as marked along the complete length inner and outer (7.1.1 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing above wheel front and rear as marked in several places (5.3.6 (a) (i))

Offside Headlamp aim too high (4.1.2 (a))

Offside Integral body structure is deformed and structural rigidity is significantly reduced inner sill and outer body sill unattached (6.1.1 (a) (i))

Offside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced wing in several places as marked before and after the rear wheel (7.1.1 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer and inner body sills as marked in several along the complete length of the sills inner and outer (7.1.1 (a) (i))

Position lamp not working all side lights not working (4.2.1 (a) (ii))

Position lamp with a multiple light source more than 1/2 not functioning all not functioning (4.2.1 (a) (ii))

Rear Electrical wiring insulation so damaged or deteriorated it is likely to cause a short-circuit around the tow bar wires hanging smoe bare (4.11 (c) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

after market additional front indicators lamps fitted of the sequential type

after market day time running lights fitted to the front of the vehicle and only the near side works

under side of vehicle rusty weak and welded in places

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement arm rear bush splitting (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement arm rear bush splitting (5.3.4 (a) (i))

Offside Front Headlamp light intensity severely reduced wiring issue on bulb holder (4.1.4 (a))

Offside Rear Parking brake inoperative on one side little or no effort (1.4.1 (a))

Nearside Front Brake hose connection leaking on a hydraulic braking system flexy joint into calliper leaking under pressure (1.1.12 (c) (ii)) DANGEROUS

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement arm rear bush splitting (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement arm rear bush splitting (5.3.4 (a) (i))

Nearside Front Seat belt anchorage prescribed area is excessively corroded outer sill holed below seat belt anchor point (5.2.6)

Nearside Front front brake binding (3.7.B.1)

Offside Front front brake binding (3.7.B.1)

Rear fog lamp switch faulty tell tail light does not illuminate (1.3.1a)

Nearside Front coil spring corroded surface rusting (2.4.C.1b)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Front coil spring corroded surface rusting (2.4.C.1b)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Stop lamp not working (1.2.1b)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Exhaust pipe in front of rear silencer box showing heavy corrosion but not leaking exhaust gases. Advise service.

Front cross member/sub frame assembly showing signs of significant corrosion but not seriously weakened. Advise service.

Nearside and offside wishbone suspension legs showing heavy surface corrosion but not seriously weakened. Advise service.

Surface corrosion at various points on vehicle underside.Advise rust treatment and service.

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Exhaust pipe in front of rear silencer box showing heavy corrosion but not leaking exhaust gases. Advise service.

Front cross member/sub frame assembly showing signs of significant corrosion but not seriously weakened. Advise service.

Nearside and offside wishbone suspension legs showing heavy surface corrosion but not seriously weakened. Advise service.

Surface corrosion at various points on vehicle underside.Advise rust treatment and service.

corrosion various parts

Rear fog lamp not working (1.3.2b)

corrosion various parts

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

slight corrosion various parts

Exhaust has a major leak of exhaust gases (7.1.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

slight corrosion various parts

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)