1998 Ford Puma

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Hazard warning switch faulty (1.4.B.1d)

Nearside Brake pipe excessively corroded (3.6.B.2c)

Nearside Brake pipe inadequately clipped (3.6.B.1)

Nearside Drive shaft which forms part of the suspension coupling gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.4.G.4e)

Nearside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Headlamp aim too high (1.8)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Brake pipe inadequately clipped (3.6.B.1)

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Headlamp aim too high (1.8)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Trailing arm has excessive play in a pin/bush (2.4.G.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Power steering pump leaking from a failed seal (2.3.3b)

Fuel pipe/s corroded

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

engine noisey

Centre Brake pipe slightly corroded (3.6.B.2c)

Front Vehicle structure has slight corrosion (6.1.A.1)

Front Vehicle structure has slight corrosion (6.1.B.2)

Nearside Front Drag link end ball joint has slight play (2.2.B.1f)

Offside Front Drag link end ball joint has slight play (2.2.B.1f)

Rear Vehicle structure has slight corrosion (6.1.B.2)

fuel pipes corroded advise

gear box oil leak advise

Front Headlamp aim too high (1.8)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Hazard warning switch missing (1.4.B.1d)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Registration plate lamp not working (1.1.5c)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Anti-roll bar linkage insecure (2.4.G.1)

Offside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7)

Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

rear brake application uneven (3.7.B.2)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Power steering component(s) has slight seepage from a component (2.3.3b)

handbrake cables begining to stick

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Power steering component(s) has slight seepage from a component (2.3.3b)

handbrake cables begining to stick

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Front coil spring fractured (2.4.C.1a)

Nearside Rear Shock absorber has an excessively worn bush (2.7.4)

Offside Rear Shock absorber has an excessively worn bush (2.7.4)

Nearside Front Direction indicator slightly discoloured (1.4.A.2f)

Nearside Headlamp aim too low and too far to the left. (1.8)

Offside Front Direction indicator slightly discoloured (1.4.A.2f)

Offside Headlamp aim too high and too far to the right. (1.8)

offside rear wheel-bearing feels rough when rotated

slight fluid leak at power-steering rack

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Nearside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front brake disc excessively pitted (3.5.1h)

Nearside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Registration plate lamp not working (1.1.C.1d)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

coolant reservoir below minimum mark

handbrake lever almost at end of its working travel