1998 Mazda MX-5

Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security all (6.2.2 (d) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Rear Anti-roll bar linkage damaged and seriously weakened (5.3.3 (b) (i))

Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security all (6.2.2 (d) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Anti-roll bar attachment bracket/mounting insecure and impairing directional stability bolt snapped (5.3.3 (a) (ii)) DANGEROUS

Offside Rear Anti-roll bar attachment bracket/mounting insecure and impairing directional stability bolt snapped (5.3.3 (a) (ii)) DANGEROUS

Nearside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive seal (5.3.6 (a) (i))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive seal (5.3.6 (a) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive seal (5.3.6 (a) (i))

clutch pedal and brake pedal rubbers poor condition

Brake lever has insufficient reserve travel (1.1.2 (a))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive seal (5.3.6 (a) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive seal (5.3.6 (a) (i))

brake pedal rubber poor condition

clutch pedal rubber poor condition

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Headlamp lens seriously defective (4.1.1 (b) (ii))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Headlamp lens seriously defective (4.1.1 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Headlamp light source and lamp not compatible hid kit (4.1.4 (c))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear fog lamp switch inoperative (4.5.3 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Sill (6.2.2 (d) (i))

Offside Rear Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Sill (6.2.2 (d) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)