1999 Rover Mini

Bonnet cannot be secured in the closed position (3.1 (b) (i))

Nearside Front Inner Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Inner Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened Nearside and Offside (1.1.14 (a) (ii))

Front Shock absorbers has a slightly worn bush Nearside and Offside (5.3.2 (c))

Front Upper Suspension arm ball joint has slight play Nearside and Offside (5.3.4 (a) (i))

Nearside Front Outer Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material Nearside and Offside (1.1.11 (c))

Vehicle treated with underseal

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust emissions - engine idle speed too high (8.2.1.2 (e))

Brake performance unable to be tested Parking brake not tested due to frayed cables. Service brake performance requirement met. (1.2.1 (g))

Nearside Rear Brake cable damaged frayed due to corrosion (1.1.15 (a))

Offside Rear Brake cable damaged frayed due to corrosion (1.1.15 (a))

Offside Rear Brake pivot has restricted free movement handbrake cable quadrant (1.1.15 (e))

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside and offside forward subframe to body bolts have been replaced with towing eyes. These bolts should have packers/washers in place,excessive movement between body and subframe not detected during test.Attention recommended.

Nearside rear suspension radius arm bolt is moving in its bracket suggesting bearing/bolt seizure.

Offside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Torsion bar (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Torsion bar (5.3.4 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Side repeater not working (4.4.1 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Torsion bar (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Torsion bar (5.3.4 (a) (i))

Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Windscreen washer not working (3.5 (a))

Offside Steering rack gaiter deteriorated (2.2.D.2d)

Nearside Inner Front Track rod end ball joint has slight play (2.2.B.1f)

both rear tyres cracking on the edge of the tread and on the sidewalls.

Nearside Steering rack gaiter deteriorated (2.2.D.2d)

Offside Front Side repeater not working (1.4.A.2c)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Steering rack gaiter deteriorated (2.2.D.2d)

Nearside rear brake recording little or no effort (3.7.B.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Nearside Front Upper Suspension arm has slight play in a pin/bush (2.4.G.2)