1998 Mazda MX-5

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear area of the nearside outer body sill has corrosion.

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside Registration plate lamp missing in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside Registration plate lamp missing in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Advise full brake check

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front front brake excessively fluctuating (3.7.B.3)

Nearside Rear Brake pipe excessively corroded to brake hose (3.6.B.2c)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front front brake excessively fluctuating (3.7.B.3)

Offside Rear Brake pipe excessively corroded rusted in clip to body (3.6.B.2c)

rear brake application uneven (3.7.B.2)

Advise full brake check

rear brake pipes greased at time of test

Offside Front Anti-roll bar linkage insecure (2.4.G.1)

rear brake pipes greased at time of test

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Very slight binding on nearside front wheel and offside rear wheel.