1999 Mercedes-benz Vito

Engine mountings to be checked

Front Brake pad(s) wearing thin (3.5.1g)

Front number plate cracked

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside rear tyre low on edge

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Engine mounts worn

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Inner Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Inner Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear coil spring incomplete (2.4.C.1a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Exhaust noisy (7.1.4)

Exhaust has a major leak of exhaust gases (7.1.2)

Offside Outer Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Rear Exhaust system not adequately supported (7.1.1)