1998 Nissan Almera

Emissions not tested vehicle overheating. (8.2.1.2 (d))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Upper Seat belt anchorage prescribed area strength or continuity significantly reduced inner arch + inside boot (7.1.1 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced sill panel (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced sill panel (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Upper Seat belt anchorage prescribed area strength or continuity significantly reduced inner arch + and inside boot (7.1.1 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Integral body structure is corroded but structural rigidity is not significantly reduced cross member. (6.1.1 (c) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Outer Sill (holed) (6.1.1 (c) (i))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both front (5.3.4 (a) (i))

Brake pipe corroded, covered in grease or other material both rear outer slightly corroded (1.1.11 (c))

Coil spring corroded both rear (5.3.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge and wearing on inner edge (5.2.3 (e))

Nearside Rear coil spring incorrectly seated on lower strut frame

Offside Front Tyre worn close to legal limit/worn on edge and worn on inner edge (5.2.3 (e))

Offside Rear Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Vehicle structure is corroded but structural rigidity is not significantly reduced offside front strut turret (lower), front cross member, both inner sill areas and rear chassis/floor pan. (6.1.1 (c) (i))

Offside Front Position lamp not working (4.2.1 (a))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Brake pipe excessively corroded pipe to flexi hose (3.6.B.2c)

Nearside Rear Inner Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Rear Inner Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

off side front and near side rear tyres worn on inner edges

rear brake application uneven (3.7.B.2)

rear brakes release unevenly (3.7.B.4)

off side front and near side rear tyres worn on inner edges

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Fuel pipe leaking (7.2.3)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp insecure (1.1.C.1c)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Headlamp aim too high (1.8)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

brake pipe to nearside rear starting to corrode at rear

nearside rear tyre on 2mm on outer edge

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

advise front number plate damaged

advise stone chips in front windscreen

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

nearside and offside front anti-roll bar end link bushes starting to perish.

nearside rear main brake pipe to flexi hose starting to corrode.

small stonechips in front windscreen.

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

nearside and offside front anti-roll bar end link bushes starting to perish.

nearside rear main brake pipe to flexi hose starting to corrode.

small stonechips in front windscreen.

advise brake pipe to nearside rear flexi hose corroded

advise nearside rear outer sill corroded

advise offside front tyre low on inner edge

Nearside Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Front Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Front Windscreen wiper blade deteriorated (8.2.2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

all 4 shock absorber dust covers split