2002 MG Zt

Heat shield insecure

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

front fogs inop

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill holed (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front fog lights inop

Heat shield insecure

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Nearside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Driver's view of the road through the swept area of the windscreen materially affected by an obstruction Widow stickers and phone holder (3.1 (a) (ii))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Service brake excessively binding Bearing not checked (1.2.1 (f))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Outer Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Nearside Side repeater slightly discoloured (1.4.A.2f)

Offside Side repeater slightly discoloured (1.4.A.2f)

Supplementary Restraint System warning lamp does not illuminate (5.4.2)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Nearside Side repeater slightly discoloured (1.4.A.2f)

Offside Side repeater slightly discoloured (1.4.A.2f)

Supplementary Restraint System warning lamp does not illuminate (5.4.2)

Nearside Front tyre has cut on sidewall not deep enough to reach ply or cords

Parking brake lever has little reserve travel (3.1.6b)

Nearside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside rear brake application uneven (3.7.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front tyre has cut on sidewall not deep enough to reach ply or cords

Parking brake lever has little reserve travel (3.1.6b)

Nearside Rear Brake pipe inadequately clipped flexi (3.6.B.1)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Side repeater slightly discoloured (1.4.A.2f)

Offside Front Side repeater slightly discoloured (1.4.A.2f)

Front Brake pipe excessively corroded (3.6.B.2c)

Brake hose has slight corrosion to ferrules (3.6.B.4e)

Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Direction indicator slightly discoloured (1.4.A.2f)

Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear brake disc excessively pitted (3.5.1h)

Offside Outer Rear Seat belt has a cut which has significantly weakened the webbing (5.2.2a)

Offside Rear brake disc excessively pitted (3.5.1h)

Windscreen wiper not operating automatically when switched on (8.2.1b)

Tyre worn close to the legal limit (4.1.E.1)