2004 Lexus IS200

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (8.1.1 (a))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Service brake excessively fluctuating (1.2.1 (e))

Front Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Fuel Pipe/s corroded ()

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Central Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Position lamp not working (4.2.1 (a))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Upper Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brake pipe slightly corroded all (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pipe slightly corroded all (3.6.B.2c)

Nearside Front coil spring broken (2.4.C.1a)

Offside Front coil spring broken (2.4.C.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brake pipe slightly corroded all (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pipe slightly corroded all (3.6.B.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Outer Body has slight corrosion sill area (6.1.B.2)

Offside Rear Outer Body has slight corrosion sill area (6.1.B.2)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Items removed from driver's view prior to test

Offside Front front brake juddering slightly (3.7.A.2b)

Parking brake lever has little reserve travel (3.1.6b)

Under-trays fitted obscuring some underside components

nearside front tyre worn on inner edge

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Items removed from driver's view prior to test

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front front brake juddering slightly (3.7.A.2b)

Parking brake lever has little reserve travel (3.1.6b)

Under-trays fitted obscuring some underside components

nearside front tyre worn on inner edge

Front wiper blade rubbers torn

Offside rear brake juddering severely (3.7.A.5b)

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Front wiper blade rubbers torn

Nearside front tyre worn on inner edge

Offside rear brake disc corroded/pitted on inner face

Offside Rear brake disc slightly pitted (3.5.1h)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear brake disc slightly pitted (3.5.1h)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Brake pad(s) wearing thin (3.5.1g)