2004 Honda Jazz

Emissions not tested (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases back box missing. (6.1.2 (a))

Headlamp aim projected beam image is obviously incorrect both. (4.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch. (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill. (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch. (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill. (5.3.6 (a) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement rear bush. (5.3.4 (a) (i))

boot floor corroded.

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush starting to split from bonding (5.3.4 (a) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Inner Suspension component mounting prescribed area damaged but not considered excessive Sill area (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush starting to split from bonding (5.3.4 (a) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Suspension & steering components corroded

Underbody corrosion

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill area (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Upper Anti-roll bar linkage ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush starting to split from bonding (5.3.4 (a) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Inner Suspension component mounting prescribed area damaged but not considered excessive Sill area (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush starting to split from bonding (5.3.4 (a) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Suspension & steering components corroded

Underbody corrosion

Other passenger door cannot be opened from outside the vehicle bootlid (6.2.3 (a))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened pitted (1.1.14 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened pitted (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Chip in windscreen.

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Brake pipe excessively corroded to wheel (3.6.B.2c)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Front registration plate deteriorated (6.3.1d)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Brake pipe excessively corroded (3.6.B.2c)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Front tyres wearing on inner edges

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear tyres look old cracking in treads and sidewalls

Rear wiper blade split

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both rear tyres cracking

handbrake just in effecency

Offside Front Tyre worn close to the legal limit (4.1.E.1)

advise rear tyres badly perished

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

advise rear tyres badly perished

front pads low

rear pads low

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

front pads low

rear pads low

Front Headlamp aim too low (1.8)