2006 Toyota Aygo

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Exhaust system insecure bracket brocken (6.1.2 (a))

Front Bumper insecure (6.1.4 (a) (i))

Front Headlamp aim too low very low (4.1.2 (a))

Nearside Headlamp insecure held on with cable ties (4.1.1 (c))

Nearside Rear Brake pipe excessively corroded to flexys (1.1.11 (c))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill/whellarch (5.3.6 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Brake pipe excessively corroded to flexys (1.1.11 (c))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Parking brake inoperative on one side (1.4.1 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Windscreen washer not working (3.5 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust mounting defective front section (6.1.2 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Emissions not tested (7.3.A.1)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Rear Registration plate lamp not working (1.1.C.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front headlight misty but not affecting headlight aim

EML on

Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Front Direction indicator slightly discoloured both (1.4.A.2f)

Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit cracking in tread (4.1.E.1)

Offside Rear Tyre worn close to the legal limit cracking in tread (4.1.E.1)

Rear Brake pipe slightly corroded both (3.6.B.2c)

exhaust bracket broken

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front brake disc in such a condition that it is seriously weakened both (3.5.1i)

Rear fog lamp not working (1.3.2b)

EML on

Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Front Direction indicator slightly discoloured both (1.4.A.2f)

Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit cracking in tread (4.1.E.1)

Offside Rear Tyre worn close to the legal limit cracking in tread (4.1.E.1)

Rear Brake pipe slightly corroded both (3.6.B.2c)

exhaust bracket broken

EML on

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Brake pipe slightly corroded (3.6.B.2c)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

EML on

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Brake pipe slightly corroded (3.6.B.2c)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

EML on

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)