2008 Toyota Aygo

Nearside Rear Brake pipe excessively damaged (1.1.11 (c))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Rear Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.1 (c) (ii)) DANGEROUS

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Windscreen washer not working (3.5 (a))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced suspension mounting (6.1.1 (c) (i))

Offside Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced suspension mounting (6.1.1 (c) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Headlamp aim too high BOTH (4.1.2 (a))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength SILL (5.3.6 (a) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength SILL (5.3.6 (a) (i))

Tyre has a cut in excess of the requirements deep enough to reach the ply or cords ALL (5.2.3 (d) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Front Brake pipe corroded, covered in grease or other material to rear. (1.1.11 (c))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material to rear. (1.1.11 (c))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

INNER FACES OF FRONT DISCS ARE CORRODED & PITTED

Brakes imbalanced across an axle (3.7.B.5b)

FRONT WIPER IS TORN

N/S/F TYRE IS WORN TO 2/2/2mm

O/S/F TYRE IS WORN TO 3/3/2mm