2010 Honda Civic

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Side repeater light intensity significantly reduced (4.4.3 (a))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Side repeater not working (4.4.1 (a) (ii))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Axle swivel pins and bushes swivel pin and/or bush excessively worn both sides (5.1.2 (b) (i))

Side repeater not working both sides (4.4.1 (a) (ii))

Rear Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear position lamp(s) has less than 50% of the light sources illuminating (1.1.A.3b)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)