1981 Vanden Plas 1500

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive floor repaired inside (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive floor repaired inside (5.3.6 (a) (i))

sill covers fitted unable to fully inspect for corrosion

vehicle underside heavily covered with sealer

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive floor repaired from inside the vehicle (5.3.6 (a) (i))

suspension low

vehicle underside covered heavily with paint/sealer

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

under side of vehicle covered in under seal

Exhaust emissions - engine idle speed too high (8.2.1.2 (e))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

under side of vehicle covered in under seal

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Rear Braking system leaking (1.1.3 (d))

Offside Rear Suspension component mounting prescribed area is inadequately repaired sill (5.3.6 (a) (i))

Both front tyres deteriorating on side walls

Front panel lower valance missing

Nearside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Nearside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

All position lamps not working (1.1.A.3b)

Battery insecure (1.9.1)

Nearside Front Side repeater not working (1.4.A.2c)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside rear brake binding (3.7.B.1)

Offside Front Side repeater not working (1.4.A.2c)

Offside Rear fog lamp not working (1.3.2b)

Rear Registration plate lamp not working (1.1.C.1d)

Speedometer cannot be illuminated. (6.7.3)

Steering wheel retaining device insecure (2.1.6)

Windscreen washer provides insufficient washer liquid (8.2.3)

Both front tyres deteriorating on side walls

Front panel lower valance missing

Nearside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Nearside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Battery insecure (1.9.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside rear brake binding (3.7.B.1)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Advise both front wiper blades rubbers deteriorated

Advise centre mirror missing

Advise front lower panel corroded

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

clutch fluid flex hose leaking

slight play in all ball joints

unable to see outer sills due to plastic covers

underside of vehicle very rusty

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear An item not tested (Manual)

Nearside Rear Tyre tread depth below requirements of 1.0mm (4.1.E.2b)

Nearside Rear rear brake binding (3.7.B.1)

Offside Steering rack gaiter split (2.2.D.2d)

clutch fluid flex hose leaking

slight play in all ball joints

unable to see outer sills due to plastic covers

underside of vehicle very rusty

underside rusty round brake + suspension areas

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Rear Seat belt insecurely fixed to the vehicles structure (5.2.1a)

Nearside rear brake binding (3.7.B.1)

Offside Front wheel bearing rough when rotated (2.5.A.2)

underside rusty round brake + suspension area