2005 BMW 116

Nearside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Rear Exhaust heat shield loose

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Rear Exhaust heat shield loose

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Brake hose slightly deteriorated Both front (1.1.12 (b) (ii))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords Split on inner edge (5.2.3 (d) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake hose slightly deteriorated Both front (1.1.12 (b) (ii))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

TPMS Lamp on

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Tyre has a tear, caused by separation or partial failure of its structure in sidewall 215/40 18 (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre obviously under inflated (5.2.3 (h) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Brake pipes covered in grease

Front Brake hose slightly deteriorated Both (3.6.B.4d)

Parking brake lever has little reserve travel (3.1.6b)

Tyre pressure monitoring system warning lamp does not illuminate (4.1.D.4)

Under trays fitted

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Brake fluid warning lamp illuminated (3.6.G.2)

Brake warning device not working correctly (3.3.D.3a)

Nearside front brake binding (3.7.B.1)

Offside Tyre fouling a part of the vehicle Wheel arch (4.1.D.2)

Brake pipes covered in grease

Front Brake hose slightly deteriorated Both (3.6.B.4d)

Parking brake lever has little reserve travel (3.1.6b)

Tyre pressure monitoring system warning lamp does not illuminate (4.1.D.4)

Under trays fitted

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Vehicles internal headlight adjuster altered to recheck lights ()

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

tyre pressure warning light on

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Bonnet cannot be secured in the closed position (8.4.1)

Bonnet retaining device insecure (8.4.2)

front tyres worn on edges