2008 Toyota Aygo

car has been undersealed (rust protection)

Front Headlamp lens seriously defective both sides (4.1.1 (b) (ii))

car has been undersealed (rust protection)

Front Brake disc in such a condition that it is seriously weakened both sides (1.1.14 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick both sides (1.1.13 (a) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Headlamp aim too low (4.1.2 (a))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Lower Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Lower Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe excessively corroded rear of front to rears (both sides) (1.1.11 (c))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Brake pipe excessively corroded Front to Rear (1.1.11 (c))

Offside Rear Brake pipe excessively corroded Front to rear (1.1.11 (c))

Exhaust bracket corroded and broken

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Both Rear Axle mounts badly corroded and thin but not holed at time of test

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Both Rear Axle mounts badly corroded and thin but not holed at time of test

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Mechanical brake component has restricted free movement (3.5.1k)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)