2006 Peugeot 107

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Rear Tyre slightly damaged/cracking or perishing both rear (5.2.3 (d) (ii))

underside of vehicle covered in mud

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement nearside and offside (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Seat belt anchorage prescribed area is corroded but not considered excessive nearside and offside inner and outer sills (7.1.1 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement nearside and offside (5.3.4 (a) (i))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Seat belt anchorage prescribed area is corroded but not considered excessive nearside and offside inner and outer sills (7.1.1 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement Nearside & Offside (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner sill (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material Nearside & Offside (1.1.11 (c))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive All rear (5.3.6 (a) (i))

Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced Floor area (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Axle Mounting (5.3.6 (a) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement Nearside & Offside (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner sill (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material Nearside & Offside (1.1.11 (c))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive All rear (5.3.6 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Horn not working (7.7 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Anti-roll bar linkage ball joint dust cover severely deteriorated both (5.3.4 (b) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

subframe coroded front

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Headlamp deteriorated but light output not reduced both front lights have foggy lens (1.7.5a)

Offside Front brake disc modified but not seriously weakened inner surface corroded and rough (3.5.1n)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Road wheel bead rim badly distorted (4.2.A.1a)