2006 Toyota Aygo

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength underbody next to rear subframe mount (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength underbody next to rear subframe mount (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is inadequately repaired outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material o/s & n/s (1.1.11 (c))

Rear Coil spring corroded o/s & n/s (5.3.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

vehicle underside has surface corrosion

Front Brake pad(s) wearing thin both side (1.1.13 (a) (ii))

Front subframe corroded

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

underbody corroded

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength both side (5.3.6 (a) (i))

Front Brake pad(s) wearing thin both side (1.1.13 (a) (ii))

Front subframe corroded

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

underbody corroded

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Brake pipe corroded, covered in grease or other material Both side. (1.1.11 (c))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material Both rear pipes at rear (1.1.11 (c))

Body has slight corrosion n/s/r sill (6.1.B.2)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

both rear tyres perishing

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

both rear tyres perishing

Nearside Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Rear Parking brake lever has no reserve travel (3.1.6b)

Rear rear brake application uneven (3.7.B.2)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)