2010 Audi A5

"3D gel" registration plates

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement inner rear (5.3.4 (a) (i))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Number plates aftermarket

Offside Front Outer Suspension arm ball joint has slight play Front arm (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Central Exhaust has a major leak of exhaust gases Clamp broken (6.1.2 (a))

Offside Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength Holes in subframe (5.3.6 (a) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Number plates aftermarket

Offside Front Outer Suspension arm ball joint has slight play Front arm (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Windscreen Washer Poor

Rear Suspension component mounting prescribed area is corroded but not considered excessive Subframe (5.3.6 (a) (i))

Under Guards Fitted

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Subframe By Lower Arm (5.3.6 (a) (i))

Offside Windscreen Washer Poor

Rear Suspension component mounting prescribed area is corroded but not considered excessive Subframe (5.3.6 (a) (i))

Subframes Have Multiple Areas Of Corrosion

Under Guards Fitted

front suspension arm bushes perishing

Central center exhuast clamps rusty corroded secure at time of test

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Front Brake pad(s) wearing thin (3.5.1g)