2012 Toyota Verso

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Horn not working (7.7 (a))

Nearside Front Upper Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement unbonding (5.3.4 (a) (i))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Position lamp with a multiple light source more than 1/2 not functioning (4.2.1 (a) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement unbonding (5.3.4 (a) (i))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Horn not working (7.7 (a) (ii))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Parking (secondary brake) on a single line braking system has no recorded effort at a wheel (1.3.1 (a) (ii)) DANGEROUS

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure tyre is miss shaped (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm bold inner edge (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Front Brake disc worn, but not excessively Both nearside and offside (1.1.14 (a) (i))

Nearside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Headlamp aim too low Both. (1.8)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Registration plate lamp does not illuminate simultaneously with the position lamps (1.1.C.1a)

Front Brake pad(s) wearing thin (3.5.1g)