2006 Seat Leon

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Shock absorbers has a serious fluid leak leaked and dried (5.3.2 (b))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Rear Parking (secondary brake) on a single line braking system has no recorded effort at a wheel both (1.3.1 (a) (ii)) DANGEROUS

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Offside Front coil spring broken (2.4.C.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Oil leak ()

nail in tyre offside rear.

Nearside Front Front suspension has excessive movement at a wishbone pin or bush (2.5.A.1c)

Electronic stability system switch faulty (3.4.5)

Rear registration plate deteriorated (6.3.1d)

Oil leak

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)