2010 Kia Picanto

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material Flex hose to wheel cylinder (1.1.11 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Exhaust has a major leak of exhaust gases Downpipe (6.1.2 (a))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material Flex hose to wheel cylinder (1.1.11 (c))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Brake pipe excessively corroded main at rear (1.1.11 (c))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Brake lever has insufficient reserve travel (1.1.2 (a))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside front to rear

both front brake pipes slightly corroded

Nearside Front Obligatory mirror insecure (3.3 (b) (ii))

Offside Brake pipe excessively corroded front to rear (1.1.11 (c))

Offside Rear Brake pipe excessively corroded to wheel cylinder (1.1.11 (c))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside front to rear

both front brake pipes slightly corroded

Nearside Front Tyre worn close to the legal limit uneven wear (4.1.E.1)

Offside Rear Tyre worn close to the legal limit inner edages (4.1.E.1)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre worn close to the legal limit uneven wear (4.1.E.1)

Offside Rear Tyre worn close to the legal limit inner edages (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust system not adequately supported (7.1.1)

Nearside Headlamp aim too low (1.8)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)