2007 Kia Picanto

Offside Front Shock absorbers has a slightly worn bush Slight play in top mount (5.3.2 (c))

Offside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill close to axle mount (5.3.6 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill next to axle mount (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure Tread splitting on inner edge (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Shock absorbers has a slightly worn bush Slight play in top mount (5.3.2 (c))

Offside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Exhaust has a major leak of exhaust gases middle/back (6.1.2 (a))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Windscreen washer not working (3.5 (a))

Nearside Front Macpherson strut pin or bush worn but not resulting in excessive movement top mount (5.3.4 (a) (i))

Nearside and Offside front lower ball joints dust covers perished

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement top mount (5.3.4 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases Back Box holed at joint (6.1.2 (a))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

ABS Reluctor rings badly corroded but still complete (Nearside and Offside front)

Nearside Front Macpherson strut pin or bush worn but not resulting in excessive movement top mount (5.3.4 (a) (i))

Nearside and Offside front lower ball joints dust covers perished

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement top mount (5.3.4 (a) (i))

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

steering and susp slight

Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

steering and susp slight

steering and susp slight

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Tyre worn close to the legal limit (4.1.E.1)