2005 Jaguar S-type

Brake pipe corroded, covered in grease or other material both front to rear (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Shock absorbers light misting of oil or has limited damping effect both front (5.3.2 (b))

Brake pipe corroded, covered in grease or other material both front to rear (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Shock absorbers light misting of oil or has limited damping effect both front (5.3.2 (b))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Rear Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Front Tyre(s) with different aspect ratios are fitted on the same axle. (5.2.3 (b))

Nearside Rear Upper Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Nearside Service brake excessively binding (1.2.1 (f))

Offside Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Tyre tread depth below requirements of 1.6mm both front (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Upper Suspension arm synthetic bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Upper Suspension arm synthetic bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

eml on

Nearside rear brake binding (3.7.B.1)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Front Statutory seat belt missing (5.1.1)