2005 MG ZS

Emissions not tested (8.2.1.2 (d))

Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both sides (5.3.6 (a) (i))

Horn not working (7.7 (a) (ii))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Other passenger door cannot be opened from outside the vehicle (6.2.3 (a))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Windscreen washer not working (3.5 (a))

Brake disc worn, pitted or scored, but not seriously weakened all (1.1.14 (a) (ii))

Front Brake pipe corroded, covered in grease or other material unions (1.1.11 (c))

Front Suspension component mounting prescribed area is corroded but not considered excessive both sides front mounts (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

under side heavily corroded

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear fog lamp not working (4.5.1 (a) (ii))

Emissions not tested (8.2.1.2 (d))

Horn not working (7.7 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear fog lamp not working (4.5.1 (a) (ii))

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive floor (2.4.A.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside front brake binding (3.7.B.1)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Registration plate lamp not working (1.1.C.1d)

Front Suspension component mounting prescribed area is corroded but not considered excessive floor (2.4.A.3)

brake disc worn, pitted or scored, but not seriously weakened all (3.5.1i)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Electrical wiring insecure (1.9.2a)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Headlamp aim too high (1.8)

brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake pad(s) wearing thin (3.5.1g)

both front tyres are worn on the inner edge of the tread.

n/s/r tyre has minor cracks to sidewall

Nearside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

o/s/r tyre has minor cuts to sidewall

Centre Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Horn not working (1.6.2a)