2011 Citroen C3

Brake performance unable to be tested Due to condition of front flexi brake pipe ferules. (1.2.1 (g))

Front Exhaust system insecure (6.1.2 (a))

Nearside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced sill area (7.1.1 (a) (i))

Offside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced sill area (7.1.1 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Exhaust system insecure (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front coil spring rubbing on inner wheel arch.

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Vehicle underside heavily corroded.

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Front Upper Macpherson strut mounting likely to fail (5.3.3 (b) (ii)) DANGEROUS

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Tyre obviously under inflated (5.2.3 (l))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Rear Tyre worn close to legal limit/worn on edge on inner edge (5.2.3 (e))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Tyre tread depth below requirements of 1.6mm on inner edge (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge on inner edge (5.2.3 (e))

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nail in offside front tyre

front mounting for back box corroded