2012 Hyundai I40

Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Drive lamp innopperitive

Nearside Front Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Drive lamp innopperitive

Nearside Front Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

undertrays fitted preventing a full inspection

Nearside Headlamp aim not tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Track rod end ball joint worn to the extent there is a serious risk of detachment (2.1.3 (b) (ii)) DANGEROUS

Brake fluid close to minimum mark (1.1.10 (d) (ii))

undertrays fitted preventing a full inspection

Reversing lamp inoperative (4.6.1 (a))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Tyre has ply or cords exposed outer sidewall (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre has ply or cords exposed inner shoulder cracked/split (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Ball joint has excessive play (2.2.B.1f)

Nearside Front wheel bearing has excessive play (2.5.A.3c)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside rear brake binding (3.7.B.1)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Brakes imbalanced across an axle (3.7.B.5b)

o/s/r lower suspension arm , ounting bolt bush insecure

Battery insecure (1.9.1)

Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords both (4.1.D.1a)

Headlamp aim too low both (1.8)