2008 Toyota Aygo

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Headlamp has a product on the lens but not seriously reducing light output both sides (4.1.4 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Parking brake lever worn, but not excessively (1.1.6 (b) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

both outter sills cocvered heavily with underseal

underbody surface rust

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Exhaust mounting defective (6.1.2 (a))

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Integral body structure is corroded but structural rigidity is not significantly reduced both sills (6.1.1 (c) (i))

Rear Suspension component mounting repair covered in underseal both (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Exhaust mounting defective (6.1.2 (a))

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Integral body structure is corroded but structural rigidity is not significantly reduced both sills (6.1.1 (c) (i))

Offside Headlamp aim too low (4.1.2 (a))

Rear Suspension component mounting repair covered in underseal both (5.3.6 (a) (i))

Emissions not tested (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Nearside Rear Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen washer not working (3.5 (a))

Nearside Front Tyre worn close to legal limit/worn on edge inner edge worn (5.2.3 (e))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Windscreen washer not working (3.5 (a))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Nearside Rear Brake pipe excessively corroded leading to front (1.1.11 (c))

Offside Front Floor excessively deteriorated drivers footwell (6.2.4 (a) (i))

Offside Rear Brake pipe excessively corroded leading to front (1.1.11 (c))

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Exhaust system not adequately supported (7.1.1)

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Offside Rear Rear wheel bearing rough when rotated (2.6.1)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Engine oil reading "min" level

Nearside Brake pipe slightly corroded front to rear (3.6.B.2c)

Engine oil reading "min" level

Nearside Brake pipe slightly corroded front to rear (3.6.B.2c)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

nsf tyre on 3mm