2008 Toyota Aygo

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Rear Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill (6.2.2 (d) (i))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust has a major leak of exhaust gases silencer (6.1.2 (a))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Inner Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both sides coated in sealant (1.1.11 (c))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced o/s and n/s inner and outer sill area (6.1.1 (c) (i))

Offside Front Macpherson strut corroded and seriously weakened (5.3.3 (b) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both sides coated in sealant (1.1.11 (c))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced o/s and n/s inner and outer sill area (6.1.1 (c) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Exhaust system insecure rear silencer (6.1.2 (a))

O/S/F tyre valve starting to crack

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

O/S/F tyre valve starting to crack

Offside Front brake disc in such a condition that it is seriously weakened badly corroded on inner face, no surface left (3.5.1i)

front brake discs corroded, pads 5 - 6mm

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

front brake discs corroded on inner face

Front registration plate delaminated but not likely to be misread (6.3.1d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear registration plate delaminated but not likely to be misread (6.3.1d)

front brake discs corroded on inner face

Nearside Front Tyre worn close to the legal limit (4.1.E.1)