2005 Fiat Punto

Exhaust rubber split

Front Brake disc worn, pitted or scored, but not seriously weakened Both (1.1.14 (a) (ii))

corrosion on floor to sills both sides

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill to arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill to arch (5.3.6 (a) (i))

Brake disc worn, pitted or scored, but not seriously weakened Both front (1.1.14 (a) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front fog light not working

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Sill covers fitted

Tyre slightly damaged/cracking or perishing Both front edges (5.2.3 (d) (ii))

Front subframe corroded

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Sill covers fitted

Tyre worn close to legal limit/worn on edge both front (5.2.3 (e))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Front subframe corroded

Rear exhaust silencer corroded

Brake disc worn, pitted or scored, but not seriously weakened front and rear (1.1.14 (a) (ii))

exhaust silencer at rear corroded

front subframe corroded

Brake disc worn, pitted or scored, but not seriously weakened front and rear (1.1.14 (a) (ii))

rear exhaust silencer corroded

exhaust rear silencer corroded

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear tyre is perished

Offside Rear coil spring cracked (2.4.C.1a)

Nearside Rear coil spring worn (2.4.C.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

front brake discs corroded

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

front brake discs corroded

rear brake discs corroded

Nearside Front brake disc slightly pitted (3.5.1h)

Nearside Rear brake disc slightly pitted (3.5.1h)

Offside Front brake disc slightly scored (3.5.1h)

offside rear tyre cut in sidewall

oil level low

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Parking brake lever ratchet mechanism is slightly worn (3.1.5)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

nsf foglamp inop

Horn not working (1.6.2a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high and too far to the left. (1.8)

Parking brake lever ratchet mechanism is slightly worn (3.1.5)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

deep cut in osr sidewall (not showing cords)

nsf foglamp inop

Nearside Rear Shock absorber has an excessively worn bush (2.7.4)

Offside Rear Shock absorber has an excessively worn bush (2.7.4)

deep cut in o/s/r tyre outer wall-not thuough to cords