2008 Toyota Aygo

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting suspension arm mounting (6.2.2 (d) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting three corroded holes in sill (6.2.2 (d) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front brake hose insecure and rubbing on strut

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Coil spring corroded Both (5.3.1 (b) (i))

Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both front (5.3.4 (a) (i))

Coil spring corroded both rear (5.3.1 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing cracking (5.2.3 (d) (ii))

Offside Front flexi brake pipe insecure

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i))

Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both front (5.3.4 (a) (i))

Coil spring corroded both rear (5.3.1 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing cracking (5.2.3 (d) (ii))

Offside Front flexi brake pipe insecure

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Emissions not tested Exhaust major leak of gases (8.2.1.2 (d))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Wheel bearing play so excessive it is likely to break up (5.1.3 (a) (ii)) DANGEROUS

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Brake pipe excessively corroded front to rear (3.6.B.2c)

Offside Brake pipe excessively corroded front to rear (3.6.B.2c)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Registration plate lamp not working (1.1.C.1d)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Exhaust has a minor leak of exhaust gases box (7.1.2)

Offside Front Tie bar/rod has slight play in a pin/bush (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Stop lamp not working (1.2.1b)

Nearside Rear Exhaust has a minor leak of exhaust gases box (7.1.2)

Offside Front Tie bar/rod has slight play in a pin/bush (2.4.G.2)

Nearside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake discs worn and corroded...

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake discs worn and corroded...