2011 Mitsubishi Lancer

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn both (5.1.2 (b) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

general underbody corrosion

fuel tank corroded

Brake pedal has insufficient reserve travel (1.1.2 (a))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

fuel tank corroded

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake performance not tested Brake fluid leak (1.2.1 (g))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Anti-roll bar has excessive play in a ball joint both (2.4.G.2)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front front brake binding (3.7.B.1)

brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)