2003 Renault Master

Nearside Front Subframe mounting prescribed area fractured significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Service brake efficiency below requirements (1.2.2 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear wheel bearing not tested due to severe brake bind

Nearside Steering rack gaiter damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Power steering pipe/hose has slight seepage at steering rack (2.1.5 (a))

Front subframe condition has surface rust @ time of test but not considered excessive

Nearside Front Brake pipe corroded, covered in grease or other material brake pipe has surface rust not considered excessive (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material brake pipe has surface rust not considered excessive (1.1.11 (c))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Rear Brake pivot has restricted free movement caliper hand brake pivot (1.1.15 (e))

Service brake efficiency below requirements (1.2.2 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Coolant leak radiator ()

Offside Rear Brake load sensing valve linkage defective and function impaired linkage rod broken (1.1.17 (a))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Brake pipe excessively corroded from loadvalve (1.1.11 (c))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Nearside Rear Direction indicator not working (4.4.1 (a) (ii))

Offside Rear Direction indicator not working (4.4.1 (a) (ii))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Brake inadequately mounted flexi brake hoses (1.1.21 (c))

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Headlamp aim too high (1.8)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Upper Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Inner Front Brake hose ferrule excessively corroded (3.6.B.4e)

Nearside Outer Front Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Upper Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Inner Front Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Outer Front Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Outer Rear Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Offside rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2) DANGEROUS

Rear registration plate deteriorated (6.3.1d) DANGEROUS

Offside Headlamp aim too high (1.8)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.5c)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2) DANGEROUS

Nearside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2) DANGEROUS

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2) DANGEROUS

Offside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2) DANGEROUS

Centre Seat belt retracting mechanism defective (5.2.5b)

Front registration plate deteriorated (6.3.1d)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Headlamp aim too high when the centre of the headlamp is above 850mm from the ground (1.6.B3)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)