2007 Audi A6

Brake hose has slight corrosion to ferrule both fronts (1.1.12 (f) (i))

Brake hose has slight corrosion to ferrule both rears (1.1.12 (f) (i))

Exhaust emissions exceed default limit of 1.5m-1 (8.2.2.2 (b))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Oil leaking excessively from engine (8.4.1 (a) (i))

Brake hose has slight corrosion to ferrule both fronts (1.1.12 (f) (i))

Brake hose has slight corrosion to ferrule both rears (1.1.12 (f) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leaking excessively from engine (8.4.1 (a) (i))

Brake disc in such a condition that it is seriously weakened both front (1.1.14 (a) (ii)) DANGEROUS

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Tyre worn close to the legal limit all (4.1.E.1)

ENGINE OIL LEAK

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Seat belt locking mechanism does not secure or release (5.2.5a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)