2012 Peugeot Expert

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Front Front passenger door cannot be opened from inside the vehicle (6.2.3 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge outer edge (5.2.3 (e))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

air bag turned off

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Windscreen wiper blade defective (3.4 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Windscreen wiper blade defective (3.4 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Rear Seat belt retracting mechanism defective rear passenger center (7.1.2 (e))

Front Service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.2.2 (a) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Upper Headlamp not working on dipped beam (1.7.5a)