2005 Subaru Impreza

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Inner sill slightly corroded

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

sill covers fitted both sides front to rear not allowing full inspection to prescribed areas

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Child Seat fitted not allowing full inspection of adult belt ()

Offside Rear Tyre worn close to legal limit/worn on edge ON THE LIMIT (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Central Stop lamp(s) with a multiple light source up to 1/2 not functioning high level stop lamp (4.3.1 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside inner and outer sills corroded

Offside inner and outer sills corroded

Rear corrosion to rear floor pan

outer sill covers fitted

Front registration plate with character(s) which are not the correct width (6.3.4a)

Front registration plate with character(s) which are not the correct width (6.3.4a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front registration plate with character(s) which are not the correct height (6.3.4a)

Front registration plate with character(s) which are not the correct width (6.3.4a)

Nearside Front Tie bar/rod has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tie bar/rod has excessive play in a ball joint (2.4.G.2)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Registration plate lamp not working (1.1.C.1d)

excess travel on h/brake

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)